OK, so small update/ question. Got a different Wii that previously had issues to install PortablizeMii with no hiccups whatsoever, so I put the first Wii back together. (And by that I mean I electrical taped the Bluetooth/WiFi Boards down, screwed the heatsink back on, put the case back on, and called it good.) The issue with the new Wii is that there is a stripped screw in the most inconvenient spot. There are two screws that run through basically the whole Wii, and the stripped one is one of those. It's about an inch from the top of the hole to the screw, so many of the methods I've tried to get it out haven't worked. I tried making a BIC pen screwdriver (It was too wide so it just mushed up around the beginning of the hole), tried using a rubber band between the screwdriver, but all this did was make the stripped screw worse. Do you guys have any suggestions on how to get it out?
I'm not even sure how the screw got stripped in the first place. Maybe there's a Wiikey at the end of this rainbow...