Latest activity

ill be greatly disappointed if this portable doesn't have atleast a bit of Mountain dew green paint on the shell (Jk, hope it goes well!)

I usually run a four CPU Ice climbers, very high pokeballs only in endless melee which I did end up doing for this current trim as I had...

I usually run a four CPU Ice climbers, very high pokeballs only in endless melee which I did end up doing for this current trim as I had...

Alright everyone, good news. I finally tracked down the right sandpaper grits for sanding my Wii, and am about halfway there (I went...

Welp, mi y stuff from china finally arrived and everything seems Ok. Iv'e wired up a nintendo switch joystick to an original gamecube...

Damn, I need to have the whole thing pretty much wired up then before I can test that. Thanks for the quick reply

Yes you need to wire up USB and boot into a Wii game with BT enabled. If it boots then success

I just wired up my bluetooth module and want to test it out but my wii-mote isn't connecting. Do I need to have RVLoader boot up fully...

Your MC joint at the bottom right looks pretty cold, try fluxing it up and clean the flux off as well

I connected HS to the wii and here is a picture of the rvl amp wiring.

I usually run a four CPU Ice climbers, very high pokeballs only in endless melee which I did end up doing for this current trim as I had...

I usually run a four CPU Ice climbers, very high pokeballs only in endless melee which I did end up doing for this current trim as I had...

@Doom

I usually run a four CPU Ice climbers, very high pokeballs only in endless melee which I did end up doing for this current trim as I had...

I've been meaning to upload these for *checks date*... weeks. The station I set up that was super messy and sticky from flux. I...