Memed
.
- Joined
- Apr 6, 2017
- Messages
- 44
- Likes
- 41
Hello! I am new to the portablizing community, so any pointers before I begin the bulk of my project would be greatly appreciated!
That aside, I am planning to make a Wii portable using the OMGWTF trim and PortablizeMii. I am going to try and make a 7.4v battery pack out of a few Panasonic batteries and a protection circuit. For audio, I've decided on 3ds speakers and a audio amp that can support 15w and 8ohms to each speaker. I think this is enough, correct me if I'm wrong. For a controller, I'll probably just hack up a 3rd party gamecube controller and connect some 3ds sliders and DS Lite buttons, but I am still unsure of what case to use. I will probably go with a ZN-40/45 from Polycase, or TRY to use an SL-68P if I am feeling ambitious. As for screens, I'm probably going to sort through the BOM and Ebay listings until I find something that works with the case I choose. I don't think I will be including a headphone jack, as I don't think I would find much use for it. For wiring, I think I'll use shielded wire (Don't know what gauge, suggestions would be appreciated) for A/V, and 32 gauge or IDE for everything else.
So far I've:
Bought a Wii (4 Layer)
Bought capacitors, resistors, batteries, etc...
Watched PLENTY of videos on basic electronics; soldering, voltages, amps, other stuff
Went through numerous guides and worklogs
Worked on Dremeling skills
If I forgot anything, don't hesitate to let me know.
Wiish me luck!
That aside, I am planning to make a Wii portable using the OMGWTF trim and PortablizeMii. I am going to try and make a 7.4v battery pack out of a few Panasonic batteries and a protection circuit. For audio, I've decided on 3ds speakers and a audio amp that can support 15w and 8ohms to each speaker. I think this is enough, correct me if I'm wrong. For a controller, I'll probably just hack up a 3rd party gamecube controller and connect some 3ds sliders and DS Lite buttons, but I am still unsure of what case to use. I will probably go with a ZN-40/45 from Polycase, or TRY to use an SL-68P if I am feeling ambitious. As for screens, I'm probably going to sort through the BOM and Ebay listings until I find something that works with the case I choose. I don't think I will be including a headphone jack, as I don't think I would find much use for it. For wiring, I think I'll use shielded wire (Don't know what gauge, suggestions would be appreciated) for A/V, and 32 gauge or IDE for everything else.
So far I've:
Bought a Wii (4 Layer)
Bought capacitors, resistors, batteries, etc...
Watched PLENTY of videos on basic electronics; soldering, voltages, amps, other stuff
Went through numerous guides and worklogs
Worked on Dremeling skills
If I forgot anything, don't hesitate to let me know.
Wiish me luck!
Last edited: