- Joined
- Feb 25, 2016
- Messages
- 1,437
- Likes
- 2,887
This one is a commission based around the Datamax case. I have had this case sitting for a while and the buyer wanted a bigger screen so finally got a chance to use it. This is a 5.6 inch screen. It says the minimum voltage is 9v online, hopefully it'll run off of 7.4v although I have my doubts, in which case I either need a 11.1v pack or a step-up regulator. The shoulder buttons will be original ps2 ones frankencased on the bottom of the case.
The case was created by cutting out the face of the datamax case, replacing it with a plastic sheet which I had used an xacto blade to cut out the screen cut and then the controller buttons frankencased in too. So a gallon of super glue, a pound of JB steelstik, and a pound of bondo later and this is where I'm at.
The case was created by cutting out the face of the datamax case, replacing it with a plastic sheet which I had used an xacto blade to cut out the screen cut and then the controller buttons frankencased in too. So a gallon of super glue, a pound of JB steelstik, and a pound of bondo later and this is where I'm at.
Attachments
-
2.8 MB Views: 1,773
-
2.7 MB Views: 1,572