Solved U10 relocation failure?

[AtHereG12]

While trying to desolder the u5 chip i notice that the pads of 4 and 5 are completely off, is this board done for? Board number c/rvl-cpu-30

 

[Shank]

You should be fine. Just run the u10 wire like normal, and run 3.3v to the other pin that you normally don't run a wire to.

 

[AtHereG12]

Oh thank you i thought i messed up, now lets see if this could work

 

[Shank]

If you burnt off the pad it's very likely you have your iron too hot. You may want to turn down the heat

 

[AtHereG12]

Yep was thinking of that too i will lower it, just got this new soldering iron and kind of dont like it. Oh well.

 

[Luke Meadows]

i had the same problem but it was the bottom one far left, am i OK too ?

 

[cheese]

i had the same problem but it was the bottom one far left, am i OK too ?

Do you still have the middle of the bottom three? That is the only one of those that are needed (the other two bottom ones are just pads connected to nothing).

 

[Luke Meadows]

yes, I will add a picture

 

[Luke Meadows]

Do you still have the middle of the bottom three? That is the only one of those that are needed (the other two bottom ones are just pads connected to nothing).

i meant to reply lol

 

[GingerOfOz]

That won't be an issue. Just make sure all 3 of the ground pins on U10 (the three right next to each other) are all soldered together.

 

[Luke Meadows]

That won't be an issue. Just make sure all 3 of the ground pins on U10 (the three right next to each other) are all soldered together.

ok thanks