Question Regulator accuracy

[Geostigma]

Hey !
My project of wii portable advance I soon finished the modeling 3d. After which I will add the manufactured components. But there :
I manufactured with 4 regulator Ti a table and the latter provided me the following voltages 4.9V; 3,24V; 1.13v and 0.99v is this going to pose problem ?

 

[GingerOfOz]

I would change your resistance on the 3.3v line. That probably won't be close enough to 3.3v to work reliable. When choosing resistors, be sure to go through and measure each resistor with a multimeter because resistors are generally close, but not exact to the value indicated. All of your other regs sound good! Good luck!

 

[Shank]

If those voltages are under load (meaning while actually powering things), then they should be close enough. The voltages tend to drop a bit when you actually use them to power something rather than just on their own.

 

[Geostigma]

Okay i going to change the 3,3v resistor
I just worried because these are very precise voltage values for the gpu and cpu.
I post the result in a worklog when i have print my case
Thanks !

 

[Dannyfaradyne]

What resistor values are you using for your regulators?