Gh0st
.
- Joined
- Aug 6, 2023
- Messages
- 13
- Likes
- 1
Hey everyone! I could definitely use some help..
I started an Ashiida build and ended up with an OM6 motherboard. I also accidentally ordered a PMS lite instead of the PMS-2, not realizing that the 1.8v connection on the lite was not an output, and I'm still not sure that this is required. I removed the u8 and used the PMS u10 emulation. When I power the board, the CPU gets warm and the av connection flickers briefly on the display, but then it's just a no signal. I should also note that I enabled VGA through RVloader, but I don't see this being an issue. Any help is greatly appreciated.
I started an Ashiida build and ended up with an OM6 motherboard. I also accidentally ordered a PMS lite instead of the PMS-2, not realizing that the 1.8v connection on the lite was not an output, and I'm still not sure that this is required. I removed the u8 and used the PMS u10 emulation. When I power the board, the CPU gets warm and the av connection flickers briefly on the display, but then it's just a no signal. I should also note that I enabled VGA through RVloader, but I don't see this being an issue. Any help is greatly appreciated.