trim

Introduction This guide and its graphics were created by me, to the best of my knowledge and certain. But without guarantee of correctness! (Even if everything has been tested by me)! So make sure that you know what you are doing, as I will not be responsible for any damage or harm you might do...

So I was wiring up the 3v lines to the bluetooth module and I accidentally hit the ground pin of my power switch (soldered to the board ground) with the end of one of the wires because I'm dumb and wasn't being careful and paying attention. Saw and heard a spark and now the board wont boot. The...

As the title implies, I've got no rumble in my cube controller after a trim on a 4 layer board. The rumble worked before the trim and the controller is getting 5 volts so I'm not really sure what's going on here. The trim works fine as well (obviously). I have a wasp fusion installed on a cube...

Well, just like the title says my trim isn't booting. The cpu and gpu both heat up slowly. The board worked just fine before the trim, and I have checked all of the regs multiple times. U10 is wired up with the trace cut and is receiving power. Nothing happens for a bit when I turn the power on...

I trimmed my wii(6layer) but now it won't power on plz help.could this likely be caused by not sanding with the right grit? Or did I just cut something important? Unless I have to if rather not do the omgwtf trim. This trim will fit fine in my case.