regulator

I need a step up converter for my screen which uses a 12V backlight for my Wii. The screen is 10 inches and the power usage according to the driver board is 12V and more than an amp. I've read that simple ones from amazon or ebay are bad to use and I only need 12v for the screen and the Wii will...

Hi guys, this is my first project. After reading and reading I decided to cut one of my Wii, the process was fun and also the location of the U10. After I mounted some cheap regulators I tried to test them and these were the results. The Wii turns on and I have component video, the USB is...

For some reason I am getting 11.6v on all my regulators and I don't know why. (Btw I'm using 12v source from the Wii Wal wart)

Hi, I am using 4 PTH08080 TI regulators in my PS2 Portable build. Under the trimming guide, it recommended a 1.75V linear regulator instead of a switching regulator set to 1.75V. I had to order the regulators in lots of 2, so I have 4. Should I just use a switching regulator or should I shell...

So basically an easy to use Pcb for the TI (Texas Instruments)PTH08080WAH regs. I will basically be designing this in Ki cad, I think i have all the right stuff for it... Okay, i cant find the specific values for the resistors but i found closest to what it needs, So my question is will these...

Well, just like the title says my trim isn't booting. The cpu and gpu both heat up slowly. The board worked just fine before the trim, and I have checked all of the regs multiple times. U10 is wired up with the trace cut and is receiving power. Nothing happens for a bit when I turn the power on...

So I'm curious, what does everyone do for resistor values regarding the pth08080w regulators? They require some pretty oddly specific resistance to get the needed voltage for wiis so I haven't been able to find singular resistors with the correct values. I haven't actually strung them together...