- Joined
- Aug 28, 2016
- Messages
- 12
- Likes
- 5
Hello Bitbuilt! I recently purchased a WASP fusion with swiss autoboot already on it. I tested it by installing it on my wii and it works fine on swiss v0.4. However, on my gamecube it is not working. When I turn the gamecube on, the following happens:
-blue light on wasp appears
-gamecube menu appears
-10 seconds later, "an error has occurred"
-blue light on wasp shuts off
Just to note, when I navigate the menu to disc loading screen, it has a "?" and says "reading disc." How do I get my wasp to boot automatically when the gamecube is turned on?
Things to note:
-the gamecube motherboard is CPU 11
-I manually soldered the wasp fusion using an FFC board
-Pin 29 is connected to ground with a thick wire
-region on wasp is set to NTSC (off, on, on, on)
-blue light on wasp appears
-gamecube menu appears
-10 seconds later, "an error has occurred"
-blue light on wasp shuts off
Just to note, when I navigate the menu to disc loading screen, it has a "?" and says "reading disc." How do I get my wasp to boot automatically when the gamecube is turned on?
Things to note:
-the gamecube motherboard is CPU 11
-I manually soldered the wasp fusion using an FFC board
-Pin 29 is connected to ground with a thick wire
-region on wasp is set to NTSC (off, on, on, on)