Need help after trimming ps2 won’t output video pms seems to work and have correct voltages
Oh dang I checked like 4 times and never saw that I’ll clean it up and test again thanks .I think you have a little shit of solder that make a short here :
Always check that there is no solder that has fallen in places where you would not want before powering your board.
View attachment 15681
What type of PMS you use ?Update
I cleaned up and rewired everything and still won’t output video I get the correct voltages and pms charges
Mhh strange ...I’m using the one from bitbuilt store ps2 was working perfect before I decided to trim a bit more
Why use an Ldo? also I still get 5v there I’ve tested all the voltages from every point and they seem to be work
I have a push button connected to the reset spot on ps2 and other end to the pms.Everything looks fine from what I can see. Are you pressing reset connected to ground?
Check continuity from the 5v spot to 5v on the video encoder. Just to be sure there isnt some current leaking somewhere and that is what you are measuring.
This spot later tonight I will make changes and test resistance thanks for the helpWhich spot on pms? It is suppose to be to ground (any ground). Or you can connect the ps2 reset to the R pad which will do the signal automatically. But for testing purpose its better to use a pushbutton until you verify it working.
No I mean measuring the resistance, it should be close to 0 ohms
I’ll test later tonight thank you for the help I appreciate it.Oh alright thats not correct. BTN is wired to tact switch to ground. This turns on the regulators when you hold it down for 1 second. Another switch to ground is wired to ps2 reset which turns on the ps2 after voltage is applied
Do you have press the first button (PMS button), then the PS2 reset.Update so I soldered the reset button to push button and ground powered on and still no video out here’s the measurement
Let me know if I did it right thanks View attachment 15718
I press the pms button first and then the reset button on ps2, my screen flickers when I press reset button on ps2 but nothing showsDo you have press the first button (PMS button), then the PS2 reset.
Not both at the same time ?