Hi there, I'm working on setting up my GC+ for my GC portable. I had a couple of questions regarding setting up the internal controller. I would like to use tact switches for the buttons, use the GC sticks, and retain the analog shoulders without dual tact. I desoldered the stickboxes and shoulder sliders.
1. I found this pinout for the c-stick box, is it the same for the control stick?
2. Does anyone have the pinout for the shoulder sliders? I see that there's 5 pins on the slider.
EDIT: found this image, but still unsure what the 2 pins on the bottom are for
3. Can I just run wire straight to the GC+ for all of these? No resistors or anything needed?
4. What are the holes for on the GC+?
5. What strategies do you guys use to mounting the tact switches/shoulders/stickboxes to your casing?
Thanks!!!
1. I found this pinout for the c-stick box, is it the same for the control stick?
2. Does anyone have the pinout for the shoulder sliders? I see that there's 5 pins on the slider.
EDIT: found this image, but still unsure what the 2 pins on the bottom are for
3. Can I just run wire straight to the GC+ for all of these? No resistors or anything needed?
4. What are the holes for on the GC+?
5. What strategies do you guys use to mounting the tact switches/shoulders/stickboxes to your casing?
Thanks!!!
Last edited: