Guide Resin Casting / Molding Buttons

Gman

RTFDS
Staff member
.
.
.
.
.
Joined
Feb 25, 2016
Messages
1,432
Likes
2,841
I had similar trouble, looked exactly the same. I would try my best to fill both sides separately, then sandwich them together and put a small weight on top while it dries. There would be some overflow so do it on a disposable surface. Molds should in good practice be designed with pour spouts and over flow holes to get perfect amount. then the spouts are trimmed off afterwards. But this can be difficult engineering for hobby molds we make.
 

Nold

real emulation, no hardware
Staff member
.
.
2021 1st Place Winner
Joined
Jul 16, 2017
Messages
441
Likes
1,593
Location
EU
Portables
5 + 1*π
Covering all parts/surfaces of the mold with resin, slowly putting them together & using a small weight seems to have done the trick. thx Gman.
 
Joined
Nov 28, 2022
Messages
1
Likes
0
To get the most out of your Resin Molds, it is important to prepare them before each use. This will help ensure that your molds last longer and produce better quality casts.
There are a few simple steps that you can take to prepare your Resin Molds for each use:
 
Last edited:
Top