- Joined
- May 30, 2017
- Messages
- 41
- Likes
- 30
Just want to make sure of a few things before I start my portable project (ill be putting up a worklog on here for all to see), I've already done a boatload of research and have my materials.
1. I did not find any premade CAD files in the 3d printing section.. is there a resource where you guys go to for these? Or do you typically make your own? I found a gameboy advance plastic case that ill be using for my portable, but if things go wrong I want the 3d option as a backup.
2. Expansion pack is a pita to trim and nearly impossible to relocate, yet it seems crazy to not be able to play majoras mask on my portable . Whats the consensus here? Trim up the jumper pak and desolder/replace the ram with 4mb from the mem pak? Can I trim the Jumper pack like so?
thanks for very much for taking the time to read this and answer any of my questions
1. I did not find any premade CAD files in the 3d printing section.. is there a resource where you guys go to for these? Or do you typically make your own? I found a gameboy advance plastic case that ill be using for my portable, but if things go wrong I want the 3d option as a backup.
2. Expansion pack is a pita to trim and nearly impossible to relocate, yet it seems crazy to not be able to play majoras mask on my portable . Whats the consensus here? Trim up the jumper pak and desolder/replace the ram with 4mb from the mem pak? Can I trim the Jumper pack like so?
thanks for very much for taking the time to read this and answer any of my questions
Last edited: