Worklog g-wii build

[jefflongo]

So like I can use 2 3.3v leds and use a couple low value resistors? I wouldn't be sure how low to drop them

Yes, just try several resistors between 100 ohms and 1k ohms.

 

[The_Smeags]

Everything minus the controller is wired up and running at this point, with the pms on hand I was forced to remove the component on the screen that lets me run it at 5v. I also detached the header for the screen controls
I might not have the room for the board that held the original tact switches so I'll probably make the custom resistor circuit. I also messed up my back half so the edges warped a little, I got a new one that I'm fixing up -- also had to patch up the on/off switch to replace it with a hole. Not sure if the final color pallet is going to be used?

 

[The_Smeags]

Currently have the front layed out, the abxy and dpad are screwed in place, wired up to the gc+ that I got years ago from aurelio, I still have the sand the holes for the joysticks so they stop sticking but they're gonna be set in place towards the end of the front assembly. I'm going to wire up the screen and amp soon so I can make sure it all works (and the menu controls might be wired wrong)

 

[jefflongo]

Wiring looks great!

 

[The_Smeags]

Wiring looks great!

Thanks I owe the credit to all of you guys for all the noodz showing how to do it.

 

[diamoomond 1]

How did you get your case? Did you print it or buy it off someone?