Worklog First Wii mod - Making a Micro

[Hydropper]

Hi! I'm relatively new to the bitbuilt community, and I'm finally getting down to the point of ordering things to make a Wii Mini. I'm mostly doing this as a learning project, because I definitely can't make a portable right now. I already have a dremel to trim with, but that's about it. I'm looking to have an HDMI port and 2 gamecube ports. Maybe USB-C for power, and ofc 2 USB ports, sensor bar, and an SD slot in the back. I might need some help as I really don't know much about what I'm doing, or where to find stuff. Wish me luck!

 

[Pablo]

SD slot is a bit awkward for a first build tbh, the rest sounds very doable though, best of luck!

 

[when the]

Hey there! I'm pretty much in the same spot as you, relatively new and probably not ready to make a portable yet, so I'm looking at making a microconsole. Eager to see where this goes!

 

[Littlehat221]

HDMI port

Using a adapter adds some lag, but when I used a wii2hdmi adapter it wasn't noticeable to me. Not sure if it matters to you though.

 

[Stitches]

Hi! I'm relatively new to the bitbuilt community, and I'm finally getting down to the point of ordering things to make a Wii Mini. I'm mostly doing this as a learning project, because I definitely can't make a portable right now. I already have a dremel to trim with, but that's about it. I'm looking to have an HDMI port and 2 gamecube ports. Maybe USB-C for power, and ofc 2 USB ports, sensor bar, and an SD slot in the back. I might need some help as I really don't know much about what I'm doing, or where to find stuff. Wish me luck!

Using a adapter adds some lag, but when I used a wii2hdmi adapter it wasn't noticeable to me. Not sure if it matters to you though.

The HDMI conversion boards from Electron Shepard would be best for this. They're a lot better than chinesium Wii2HDMI units. They also sell a hand dandy breakout board for the Gamecube controller port to make things a little easier