Shank's latest activity

Last summer, @Wesk and I were theorycrafting a Wii reg board for undervolting that would solder directly to the motherboard. Such a...

World's Smallest Nintendo Wii, using a trimmed motherboard and custom stacked PCBs https://github.com/loopj/short-stack Features...

MGC, the best time of the year.... okay dump time! Had to start off the meetup by comparing Wiis to see whose is smaller ( ͡° ͜ʖ ͡°)...

The LOLWUT trim is replicable (and no this isn't an April fools joke)! Thanks to Yveltal's guide (and my questions throughout these past...

Reviving this Wii is likely possible, but it would take a very experienced modder to do so. It's safe for you to call this board a...

Brief update: Not too much has changed but I did correct everything I think I need to for this design to boot. Guess I'll find out. -...

Caféflex is complete and open source on GitHub: LINK Caféflex usage will eventually be integrated into the trim guide; in the meantime...

Here’s my finished Ashida! After giving up on this project last August, I persevered to complete it! Special thanks to CrazyGadget for...

I appreciate your input. I was actually able to get further information from YveltalGriffin and Marshall: - RAM trace impedances should...

Thank you, definitely not giving up! Still actively working on the RAM termination, just seems to be more complex and involved than I...

Thank you for sharing, I may look into the N64Brew discord. I didn't know exactly what I was getting myself into with this board...

Absolutely unreal

Because it was very challenging to do one, cause of UGE power draw and a lot of heat, this project was very challenging and took me...

PCB: https://github.com/Gmanmodz/N64-Controller-Module Joystick Converter MCU: https://github.com/Gmanmodz/N64-Joystick-Converter For...

I appreciate the troubleshooting suggestions. - Cartridge is in the correct orientation and even probed every single pin to the RCP/PIF...