Question Troubleshooting GC+ 2.0

[Aurelio]

Probably the pic16 was not programmed properly or fried，which was most problems i met when gc+ did not function

All the GC+s we sell on the store are tested to make sure they fully work before being shipped

 

[xsping]

It works fine when I plug it into my GameCube though

can gc+ directly plug into GameCube controller？？？

 

[darascope]

can gc+ directly plug into GameCube controller？？？

I just took a spare GameCube controller cable I had and wired it to the GC+

 

[xsping]

I just took a spare GameCube controller cable I had and wired it to the GC+

check the resistor array on the wii board， if it shows not 10k， Try add 10k resistor between data and 3.3v，sorry for bump old thread

 

[Aurelio]

check the resistor array on the wii board， if it shows not 10k， Try add 10k resistor between data and 3.3v，sorry for bump old thread

The resistor array on the Wii is 700 Ohm, not 10k

 

[darascope]

The resistor array on the Wii is 700 Ohm, not 10k

I'm only getting about 600 Ohms

 

[Aurelio]

I'm only getting about 600 Ohms

That's fine. Measure it on the GC+ side to make sure it's properly soldered. Also did you use a thicker wire for GND?

 

[darascope]

That's fine. Measure it on the GC+ side to make sure it's properly soldered. Also did you use a thicker wire for GND?

I used thicker ground wire, but still no luck

 

[sharby2010]

I used thicker ground wire, but still no luck

Did you ever fix it?