John
.
Thought it would be fun to buy a 6-layer Wii and make a micro!
Specs will be the same as Nold's Micro as I am using the same case.
Specs will be the same as Nold's Micro as I am using the same case.
Last edited:
Worklog Wii Micro with Noldendo case
- Thread starter John
- Start date
John
.
Sanded the boards and relocated the U10 chip:
John
.
Connecting the Bluetooth module now and I am curious if I can connect pin 13 on the Bluetooth module to pin 6 on the module since they are both sense 3.3v.
Also, I am assuming for a sync button I would wire a tact switch with 3.3v to pin 12, and when I click the button it sends the voltage through and syncs?
Pics for reference:
Also, I am assuming for a sync button I would wire a tact switch with 3.3v to pin 12, and when I click the button it sends the voltage through and syncs?
Pics for reference:
John
.
I realize now that I may have wired 6 and 7 on the bluetooth to the USB 6 and 7 on the motherboard. I was a bit confused by the diagram so if anyone has input on this I would appreciate it.
- Joined
- Apr 23, 2018
- Messages
- 29
- Likes
- 54
I like this trim a lot. What are the overall dimensions of it?
About 105x100mm [H x Wmax]
