Pacal
.
Does anyone know how short the wires must be to do the rcp relocation?
Question Rcp
- Thread starter Pacal
- Start date
Pacal
.
ok ,thank you
RCP wiring is incredibly difficult. I wouldn't do it, period, unless you mess up a board bend and can't get another board easily. The board bend is a much easier and quicker technique.
I just realized that I read the question wrong. I thought you were talking about cartridge relocation.
For rcp, I agree with @Noah. The board bend is a much better route.
If you decide to do it though you are going to want the wires as short as possible. I would say max 4in but you should keep it even lower.
For rcp, I agree with @Noah. The board bend is a much better route.
If you decide to do it though you are going to want the wires as short as possible. I would say max 4in but you should keep it even lower.
Pacal
.
Well I have more than 50% of my case finish and I thought with the board bend it was gonna fit but it doesn't so now I really need to do the rcp relocation, I'm using 30 awg wire just for the relocation, do you think it's good enough or should I go for a thicker wire
