Does anyone have a stl file for the bottom shell without the sd card slot and switch slot
I just took Wesk's original STEP and removed the MX4SIO part for ya, see if that works.
Does anyone have a stl file for the bottom shell without the sd card slot and switch slot
Thank you i appreciate itI just took Wesk's original STEP and removed the MX4SIO part for ya, see if that works.
View attachment 45385
This is not an issue. You have probably have a GH-062-xx? Can you send a pic or share the board model?So I started disassembling my ps2 slim 79001 and I do not have a lid detection switch on the motherboard, so will I not be able to do this mod
It is a GH-62-02This is not an issue. You have probably have a GH-062-xx? Can you send a pic or share the board model?
Look through these posts, should help you.
I used an "L-shaped" piece of a project PCB board and fashioned it as shown below, with a PCB push button. You’ll need to shorten the plunger for your power button. I’ve done this on three of my builds, so I know the feeling when you pop open the shell and think, "uhh...", ha ha ha!!
If you're interested, I can get you the part numbers for the PCB, push button, and some more pics.
This stuff is so much fun!!!
![]()
![]()
who am I kidding.... I can't help myself I have to share all the info I have.
- Cut the PCB into a 5 via by 5 via square.
- Cut from the square a 2 via...
Power / Reset Button
The mushy lid switch had to go and was replaced with a tactile push button. When using the lid switch, the unit would sometimes reset if you simply bumped the console — very annoying. This particular board still had the lid switch present, so I was able to simply remove it and replace it with a tactile push button.
![]()
I found these push buttons on AliExpress and ordered a few different sizes. I sized it to be about the same height as the original lid switch off the motherboard. The size that worked out best was a copper SMD 4 × 4 × 3.5 mm...
Yeah I've never soldered before and this is a project that I've been wanting to do it just took a bit finding a ps2 that would work and wasnt an arm and a leg, but you have been very helpful and I appreciate itJust sifting through some posts trying to find a few examples. I have some boards taht I have made but I know that does not help you. I am working on a store to make my mods available, but not yet.
You can use the switch board (SW Board).