Worklog Getting the PS2 smaller

Other than the omitted 16 bit support, looks OK

Since the pins are there, you might as well hook up the 16 bit stuff, and mux BYTE# and Q15 accordingly to /BYTE. That will allow faster accesses with custom drivers
 
As far as I understand, 16 bit is not used for booting the rom0, right? I guess it would allow faster reprogramming, but that is not really necessary
16 bit is not used in the process of booting. But it will allow faster access r/w with custom drivers.

It may be possible that some chips can only be flashed if the full address/data range is available, but not too sure about this
 
16 bit is not used in the process of booting. But it will allow faster access r/w with custom drivers.

It may be possible that some chips can only be flashed if the full address/data range is available, but not too sure about this
Looks like this chip can be programmed in byte mode, so looks fine! Thanks for the quick reply. Not really concerned with R/W access, at least not yet

Screenshot from 2026-10-31 02-59-07.webp


I think I finally did it, what a glorious battle that was, had to rip off the fpga and move it over, not proud of it, but at least I managed to route it, I don't regret going for 8 bit width only


UPDATE:

Making good progress with the PCB, still plenty of things to do, but I think I have the parts placement more or less down.
inner1.webp

inner2.webp



Still working on the routing, the power islands in the inner layers are a bit tedious, but, aside from 2.5v, others are routed/ almost routed.

One of the major design changes, I decided to move away from the stm32, and decided to use an esp32 wroom module, firstly, its nice because there are less passives to fit. And second, possibly the biggest reason: BT audio! I was looking and thinking where to place the 5v buck, and then I realised, nothing on this board actually needs 5v, And I dont really need a DAC if I use an esp32 as a I2S to A2DP bridge, Threw a quick test together on my test board, and sure enough, I can get it to stream ps2 audio to some BT headphones. Of course, Ill leave I2S accessible on some test pads for a possible external dac, if speakers are desired
 
Last edited:
Checked. Doing PSX witchcraft making DSP not respond. So custom DEV5 for fats is possible without internal mods.
 
The board really did come out tiny — that's a huge step from where this started. Good luck with the EE and GS reball, that's the nerve-wracking part. And Hpela's note about a custom DEV5 on a FAT without internal mods is a nice bonus if this ever turns into something more people can use.
 
So, here is the big update:
IMG_0046.webp


Took quite a bit longer than expected, but finally managed to get the chips reballed and soldered on, all power rail resistances seem to be reasonable, will have a hard time testing it, as most parts are still on the way, but the idea is to currently use a donor ps2 to provide the clocks and power rails, and just to see if it starts fetching the bios

Some details about the reballing process:
IMG_0016.webp

55FA8E89-145C-4E69-A452-E91560E27DB6.webp


Well, I decided to do it the hard way, with tweezers and a steady hand, well, I’m NEVER doing that again, stencils already on the way for a future revision!
 
Back
Top