ToxicBananaFish . Joined Jan 9, 2021 Messages 25 Likes 2 Location North Carolina, U.S. Oct 22, 2023 #1 The pad that the built in 1.8v regulator decided to come off of the board with the regulator itself, pulling up a resistor labeled "R1" with it as well. Will my board still be able to work after it's trimmed? This is the best picture I could get.
The pad that the built in 1.8v regulator decided to come off of the board with the regulator itself, pulling up a resistor labeled "R1" with it as well. Will my board still be able to work after it's trimmed? This is the best picture I could get.
Stitches 2 and a Half Dollarydoos Staff member . . Joined Feb 5, 2017 Messages 3,853 Likes 3,026 Location Banana Bender Land, Australia Portables 6 Oct 22, 2023 #2 Yeah it'll work fine. You just need to run the 1.8v supply wire to the black tantalum capacitor instead of the LDO footprint
Yeah it'll work fine. You just need to run the 1.8v supply wire to the black tantalum capacitor instead of the LDO footprint
ToxicBananaFish . Joined Jan 9, 2021 Messages 25 Likes 2 Location North Carolina, U.S. Oct 22, 2023 #3 Alright, thank you so much! It's late (where I am) right now but I just finished trimming the board, I plan to do some testing tomorrow!
Alright, thank you so much! It's late (where I am) right now but I just finished trimming the board, I plan to do some testing tomorrow!