MechX
.
- Joined
- Nov 13, 2020
- Messages
- 20
- Likes
- 4
Hi all,
So I'm doing my U10 relocation to U5, and I'm having a bit of trouble with soldering to the via for the jumper wire.
I've tried adding flux, and just trying to get solder on the via to no success. I've also tried soldering a tinned magnet wire - to again, no success.
Is there any other way to access this signal? Or any tips here, I've soldered to vias before and even this one! on another board - I had no issue with this particular task last time, but for somereason it's an issue now!
Kindest regards and many thanks,
Leon.
So I'm doing my U10 relocation to U5, and I'm having a bit of trouble with soldering to the via for the jumper wire.
I've tried adding flux, and just trying to get solder on the via to no success. I've also tried soldering a tinned magnet wire - to again, no success.
Is there any other way to access this signal? Or any tips here, I've soldered to vias before and even this one! on another board - I had no issue with this particular task last time, but for somereason it's an issue now!
Kindest regards and many thanks,
Leon.