Tedzors
.
- Joined
- Aug 19, 2017
- Messages
- 17
- Likes
- 3
Hi everyone,
Have a bit of what might seem a silly question but couldn't really find an answer from looking at all the different trigger L/R designs. I was basing this trigger off Jackson's Wii sp 2, since this is the sort of case I want to design.
Currently, in Fusion 360, I have completed the following design attached below. The issue with this design is that I can only get the full press when I press down on the very edge of the trigger.
How would I get it so the full press happens if I press any part of the trigger? From the design with the wii sp 2 I can't really tell how the trigger itself is shaped as there are no pictures of the internals with said triggers in. The design itself looks similar to the one in the G-Wii.
What do I need to add/change to make it this possible?
Have a bit of what might seem a silly question but couldn't really find an answer from looking at all the different trigger L/R designs. I was basing this trigger off Jackson's Wii sp 2, since this is the sort of case I want to design.
Currently, in Fusion 360, I have completed the following design attached below. The issue with this design is that I can only get the full press when I press down on the very edge of the trigger.
How would I get it so the full press happens if I press any part of the trigger? From the design with the wii sp 2 I can't really tell how the trigger itself is shaped as there are no pictures of the internals with said triggers in. The design itself looks similar to the one in the G-Wii.
What do I need to add/change to make it this possible?
