Question Case material

[Brock903]

I'm looking to print out an Ashida case and I don't have a printer, so I'm opting to use PCBWay instead. I'm trying to find a cheap material that's strong. Any help would be nice.
Thanks.

 

[Stitches]

PLA is plenty strong for a case like this. You could go for PETG if you want a little extra strength, but unless you drop it heaps it won't really matter.

 

[Hexecutioner]

PLA is plenty strong for a case like this. You could go for PETG if you want a little extra strength, but unless you drop it heaps it won't really matter.

When choosing to print with PLA, what should I choose to be the infill? Or does it even matter?
Thanks!

 

[Stitches]

When choosing to print with PLA, what should I choose to be the infill? Or does it even matter?
Thanks!

For 99% of portable cases, you should print at 100% infill. The walls are usually thin enough that you don't need to specify, but it's good to set it to 100% anyway to simplify the print