Paulo
.
- Joined
- Oct 22, 2018
- Messages
- 32
- Likes
- 4
Hello!
I'm building my first portable Wii and everything is working well so far.
Today I was doing the final assembly with everything connected and it turns on and works but there is an audio problem.
To be honest this is the first time Im testing audio, should have done it before, now e everything is wired and glued in place so I have to avoid removing the audio amp as it would be a huge pain to do, my mistake not to test iti before.
As soon as it boots the audio is only static like noise, like in the old TVs when out of sync with a channel.
I have no idea why it is happening, everything is wired properly, Im using a pam8803, wire with ground on both ends, the output on the Wii is wired to the first two pins below the ampaw, the speakers are Wii u gamepad speakers and the input on the amp is also wired properly.
Turning the volume up and down will only make the static noise go lower or lowder, I cant hear anything else but static.
Any ideas on what is going on?
Thanks in advance.
I'm building my first portable Wii and everything is working well so far.
Today I was doing the final assembly with everything connected and it turns on and works but there is an audio problem.
To be honest this is the first time Im testing audio, should have done it before, now e everything is wired and glued in place so I have to avoid removing the audio amp as it would be a huge pain to do, my mistake not to test iti before.
As soon as it boots the audio is only static like noise, like in the old TVs when out of sync with a channel.
I have no idea why it is happening, everything is wired properly, Im using a pam8803, wire with ground on both ends, the output on the Wii is wired to the first two pins below the ampaw, the speakers are Wii u gamepad speakers and the input on the amp is also wired properly.
Turning the volume up and down will only make the static noise go lower or lowder, I cant hear anything else but static.
Any ideas on what is going on?
Thanks in advance.