Ashida case from PCBway

[Taradiel]

Hello to all!

I'm planning to start a new Ashida, a bit cleaner than my first one.
As I don't have a resin printer, I wanted to use PCBway.
I wanted to start with a resin print and there is a lot of choice on the material.
If any of you have ordered from them, I would like to have your feedback on the quality / feel / finish from them?
I was thinking of going with a UTR-8100 or a Somos® Taurus with purple finish. Do you have any recommendations if there is a better resin than others?
Thank you very much in advance for your advice!

 

[Cleetus_Buckwalter]

Hello to all!

I'm planning to start a new Ashida, a bit cleaner than my first one.
As I don't have a resin printer, I wanted to use PCBway.
I wanted to start with a resin print and there is a lot of choice on the material.
If any of you have ordered from them, I would like to have your feedback on the quality / feel / finish from them?
I was thinking of going with a UTR-8100 or a Somos® Taurus with purple finish. Do you have any recommendations if there is a better resin than others?
Thank you very much in advance for your advice!

Did you end up ordering a shell? If so, what did you go with and how did it turn out?