Search results

When you installed RVLoader, did you enable the VGA patch? That could be your issue. It also doesn’t hurt to rewire composite again in case you had made a slight mistake. You could try to wire Composite on the front of the board: Also even if the fan is spinning it doesn’t mean that your...

I did, I just don't have a picture of it. The issues still persist when the length is way shorter and routed away from any wires that would disrupt the signal. Also, my SDW and SCW lines are great as well, no issues there; only with that drive it seems.

I tested with different wire, shielded wire, different gauges, and more. Here is a picture of the wiring before I routed it away from everything: I have since closed up the portable. I also shortened the wire. Here is when I used super shielded wire, and the issue still wasn’t fixed until...

Myself and @zwolf64 were encountering issues with RVLoader corruption with Hiidra, etc. After rewiring the USB multiple times on Trimmed Wiis it still wouldn't work. Results of data corruption are posted below. We were both using the SanDisk Ultra Fit 3.1 (128 & 256GB variants) and both on...

Thanks so much, it was worth the time!

Thanks so much! Remember to not cheap out on tools, that’s the most important lesson I learned.

Here’s my finished Ashida! After giving up on this project last August, I persevered to complete it! Special thanks to CrazyGadget for helping me with VGA & other issues last year, and for encouraging me to finish! The case is 3D printed on an FDM printer and I sanded, filled, and painted it...

Fusion 360 Model Files

Thanks for your response, I appretiate it!

This model is to scale and can be used for whatever it might help you with! The measurements should all be good as I cross-referenced many diagrams, and I measured stuff myself as well.

Thanks for the response!

The RVL-PMS-2 just restocked on 4layertech, but before that I was just going to go with the RVL-PMS-Lite, I don't care about perfect battery life indication and the one with voltage is fine for me on the Lite version. The only other thing is the LDO on the Wii would be used instead; how...

LOL, How awesome & cool!

That's awesome! I love how you showed some of your design process, 3d printed supports, and more. How did you go about wiring up the controller boards? I'm quite curious.

Thanks so much Stitches!

I am getting into making Wii portables and this is my frist one. I've been hard at work studying where to solder certain wires and more. I was just wondering, in terms of power wiring, is this correct? - Or is there some small mistakes, etc. Please let me know and I appretaite any support! I...

Nice work! I love the look and how compact everything is.

That's honestly crazy how that looks so good. Congrats on your build & whatever you might make in the future!