Search results

Thank you so much I was struggling way too much with desoldering it

Oh by ports I meant the gamecube memory card port not the controller ports sorry if I caused any misunderstanding.

My reasoning behind was that I have no intention of doing a omgwtf trim and I intend to just use the board without the ports as I intend to make a wii laptop and aren't very confident with my skill so I decided to do something basic first. Unless doing it like this causes it to be more confusing?

So I was trying to desolder the gamecube ports off of my wii with no success can anyone suggest a effective method.(Btw I'm using a soldering iron and a solder sucker)

Would it be possible to change the output. Or would you be able to recommend a circuit which I could use which is charge and play.

So I was looking on bangood and came across this power bank charging board I was curious as to whether I can use this like charge and play circuit. https://m.banggood.com/DIY-Power-Bank-Motherboard-Circuit-Board-Lithium-Battery-Charging-Board-p-1311987.html?rmmds=search

Thank you so much

So I have a few questions about this charging board https://ebay.to/2LxIbZW. I was wondering whether it only charges 2 18650 in series or can it charge something like 2s2p 18650 setup? Also is there a way to make a Charging board similar or the same to this.

Thanks now I can start trimming the board

So I was wondering what type of dremel bit should I use I have these but I'm not sure if they will work.https://bit.ly/2NfuzyR

Ok, thanks again.

So could I use this https://hobbyking.com/en_us/turnigy-22awg-siliconewire-black-2m.html?countrycode=GB&gclid=Cj0KCQjwmPPYBRCgARIsALOziAPTe6QmovuXWZVvHFVyg2ovuY9EvpUVClMfFgsMxBChEq2rX-Vj9s0aAgpkEALw_wcB&gclsrc=aw.ds&___store=en_us

Just wondering what thickness of wire should I use for the regulators also where can I find the specific resistors? One more thing can I use this for any of it...

Thank you. Probably should have looked there first. Thanks again.

I know this isn't related but what wires should I use on the regulator and what should I use for wiring the Wii.

Thanks, Now I can finally start.

Just wondering but could I use this I'm not too sure because it seems cheap but it is definitely within my budget https://www.amazon.co.uk/Latinaric-Anti-Dust-Respirator-Industrial-Activated/dp/B01LC5XWNS/ref=sr_1_3?s=amazon-devices&ie=UTF8&qid=1527275205&sr=8-3&keywords=Respirator

Thanks, I guess I'll be buying something similar as I'm in the UK. Thank you none the less.

So I'm going to start trimming the Wii Board but I have been a bit hesitant as I've heard that the dust isn't good for your lungs and I was wondering if anyone could recommend some form of safety equipment. Hopefully not too Expensive :)

Nice, thanks Can't wait to get started now.