Can you supply a close up of your PMS and USB-C PD?
Question Trimmed Wii won’t boot
- Thread starter Someone56789
- Start date
-
- Tags
- help
Ok here’s a close up of the PMS and USB-C board.
Do you think there might be a problem with my USB-C or PMS board? Also I have a question about the LDO, why is it something that needs to be removed in order to use the RVL-PMS if it already supplies 1.8v to the board? When I was removing it from the board I didn’t use a hot air station, so I had to put my soldering iron on the board for a long period of time for it to come off. I think this might have potentially damaged my board in the process.
PvtDerp
.
- Joined
- Feb 1, 2018
- Messages
- 14
- Likes
- 16
Hey mate, you might want to shorten every Blue wire you've got running there. Each wire is showing a bit too much copper and could be causing a potential short. Desolder those wires, cut a few millimeters off of them, and resolder them back to their respective pads. You only need a fraction of copper to be attached to the pads for it to form a reliable connection.
You also might want to touch up a few solder joints on both boards, don't mean to be rude, but those joints do look a little on the colder side.
You also might want to touch up a few solder joints on both boards, don't mean to be rude, but those joints do look a little on the colder side.
