Model Sony A14/D14 BVM Bezel

[Wesk]

Sony A14/D14 BVM Bezel

CC BY​

This license enables reusers to distribute, remix, adapt, and build upon the material in any medium or format, so long as attribution is given to the creator.
The license allows for commercial use. CC BY includes the following elements:

BY: credit must be given to the creator.

 

[artophe]

This is gorgeous!. Thank you so much for sharing Wesk

 

[Wesk]

Updated original file, found that a few measurements were off by about 0.5mm to 1mm in certain areas.

 

[artophe]

Updated original file, found that a few measurements were off by about 0.5mm to 1mm in certain areas.

Hi Wesk! Thanks for updating the step file.

When I tried to upload the first version to JLCPCB, their tool detected some thin walls.
The new step file seems perfect

I still don’t know if or when I’ll place an order on JLCPCB, but if I do, I’ll try to post some photos in this thread.

 

[Wesk]

Hi Wesk! Thanks for updating the step file.

When I tried to upload the first version to JLCPCB, their tool detected some thin walls.
The new step file seems perfect

I still don’t know if or when I’ll place an order on JLCPCB, but if I do, I’ll try to post some photos in this thread.

I modified the model so I could FDM print it without supports. Fitment is about 97% perfect although it seems the clips are a little fidgety, not sure what part is off but there does still seem to be room for very slight improvements. It could also be an issue with tolerances in the print itself.