Solved How to do a U9 relocation

[AdriBoy]

Hi,
Today, I tried to do the U10 relocation, but failed and broke a leg, then, i found out that U10 relocation, can be also made with the U9, i took it and place it instead of U5.
I made the relocation as it was a U10, but i've read that i have to short 2 data lines. Do I have to do, or undo something more? Or the rest is the same as the U10 one?
Ty guys.

 

[CrazyGadget]

You only need to bridge the original U9 points on an untrimmed board for it to boot. For a trimmed board, the aforementioned doesn't matter, you just do the relocation like you would with U10.

That being said, I wouldn't give that board any power yet. The edges look really rough, I would give it a really good sanding with 120, 220, 320, 400, 600, 800, and 1000 grit sandpaper. Those solder joints on the U10/9 also look a bit cold, it would probably be good to add some flux to the joints and reflow them.

 

[AdriBoy]

Ok, thank you for the info. I still have to sand the edges as you said, im waiting to get sandpaper. I will check the solder joints aswell. Thank you again!