Question Battery/Power Switch help needed

[Gamecube]

Hi everyone,

I just had a quick question and hope someone could help.
I would like to use SS's plug and play diagram but my battery/power solution is different.

Instead of batteries with a protection circuit I have this battery pack.
It has power and charging separately. I would like to use the same switch so one position is powered by batteries and the other position is powered by wall power with the batteries charging. So there is no possibility of frying my little dolphin.

Even if theres a way to do it without charging the batteries at the same time that would be okay. I just want it so the wall power and batteries cant be on at the same time.

Any help would be much appreciated

 

[ShockSlayer]

There's nothing special about those batteries; they just have the protection circuitry inside the pack. See where it says P+ and P-? That's where the + and minus of you pack goes. Everything to the right of that stays the same.

 

[Gamecube]

There's nothing special about those batteries; they just have the protection circuitry inside the pack. See where it says P+ and P-? That's where the + and minus of you pack goes. Everything to the right of that stays the same.

Okay cool, thanks. I'll try it out later