Search results

Thank you for all the info, I will definitely replace the wiring with the same gauge and twist accordingly. I removed the U5 but never soldered up the u10. The u10 is coming from the PMS2, and I was told it wasn't needed to relocate the u10 if you were using the one from the PMS2. When testing...

Yes, tested composite and it works fine. I am actually using RVloader 1.6, still won't boot without the reset to GND. I've checked H sync and V sync with a multimeter and not getting anything from it but I am getting power from the RGB lines.

This might be a dumb question.. I soldered up the VGA, and get voltage readings from all lines except the H Sync and V Sync. Component works fine, although I have reset bridged to gnd because BBloader wont boot for some reason. 3.3v is bridged with mode and VGA patch is installed, I've rewired...

UPDATE Soldered Reset to GND and it boots to homebrew menu, however the screen is upside down haha

I apologize, just updated. 22AWG single core.

Just switched to 22AWG single core and cleaned the board as recommended. These are the readings.I noticed that the 1v line starts at 93 and slowly climbs to 119. Connected everything with the same result, cpu hot but no display. 1v - 93ohm 1.15v - 26ohm 1.8v -36ohm 3.3v - 553ohm 93 26 36...

Will do! I haven't actually, I'm fairly new to the portabalizing stuff so I apologize for all the questions..

Alright, tried the suggested with no luck :/ Here is a picture of the back of the board

I apologize, I will get a pic and send it over. Only thing wired up underneath is the u10.

Alright, so I got a 4 layer board in. Setup RVloader, trimmed, threw it in.. but unfortunately still no display. I'm still using the PMS Lite, and checked output of all connections (all good), and CPU gets hot. I'm thinking it could be the component connection but not sure..

Thank you for your reply. I will find myself a 4 layer board!

Hey everyone! I could definitely use some help.. I started an Ashiida build and ended up with an OM6 motherboard. I also accidentally ordered a PMS lite instead of the PMS-2, not realizing that the 1.8v connection on the lite was not an output, and I'm still not sure that this is required. I...

Hello! Looking forward to learning from the community!