CrazyGadget

I need to finally try this build

I managed to solve the problem; by following all the instructions and measuring the values, I realized the issue was with U10. I was...

I made sure to charge it before doing the first test and its voltage was 4.2v

What's your battery voltage? I've seen this exact issue when the batteries are too low. PMS stops working when the battery is around 3.4V.

Where do I even start.. (probably with apologizing for forgetting the circle trim) This is my first and definitely not the last MGC I...

Tempowary

Hi! I've not seen you post before but I can see you've been around for a while. Welcome back to portablizing! Also I love your...

Hey everyone, this is Downing! I figured I'd make a post here about the upcoming Retro gaming convention coming up in September in...

Happy to see you release this! I remember you using this when we tested Matterhorn64 over voice a while back. This is a great little...

Hi there! A few weeks ago I designed a simple power supply board for the Nintendo 64. I used it to power the Matterhorn 64 Core...

INCOMING TRANSMISSION: COMPONENT PROCUREMENT & FEASIBILITY ASSESSMENT TO: Operational Lead FROM: Department of Unhinged Thermals &...

I forgot to post a picture like this before, so here it is! (The tin in the middle is a failed cut) Also a little sneak peek at my...

Sent you a DM as well :D

Hi guys, I'd like to buy a mini GameCube replica. I've seen two projects here on the forum: the Kawaii and the GC Nano V2. The fact...

Funny enough, we have been working on something just like that for a while. It integrates basically everything you mentioned (minus GC+...