- Joined
- Dec 29, 2016
- Messages
- 38
- Likes
- 21
Heya fam. Should have started a worklog instead but this should go. I am done with wiring the integrated controller and im very happy with it!  Soldering is sloppy but it got the work done. Looking now to seal the solder points but thinking if epoxy is better than hot glue. Never used it before. But ive stumbled upon a thread 'never to trust hot glue' and epoxy was better. The epoxy pic should be below. Really cheap. Is that good? After mixing, should i just apply it on pins and let it harden after? Or would the same result apply with hot glue nonetheless? I have both. Again. Much thanks to everyone.
Especially for the people who pointed me out last time on the controller wiring.
Especially for the people who pointed me out last time on the controller wiring.
Attachments
-
3.9 MB Views: 283
-
1.4 MB Views: 323
-
1.6 MB Views: 304