Solved Black screen help?

Joined
Jun 23, 2021
Messages
114
Likes
19
Location
Germany
Portables
None (yet)
Might be a U10 problem, but i don't know for sure. You could replace it with u9 and see if the output changes. Remember that too much heat over some time can break the chips.
 
Joined
Feb 19, 2021
Messages
49
Likes
13
Location
Germany
It's 6-layer so you might need to sand the edges a little bit more and at an angle (you should be able to slightly tell the difference between the layers)
 
Joined
Jun 6, 2020
Messages
267
Likes
307
  • Did you sand with 120, 220, 320, 400, 600, 800, and 1000 grit sandpaper? Slowly building up in the grits is very important to ensure that none of the board layers are shorting.
  • What are you using to power the Wii?
  • Did you check your trim resistances as per this guide? If that all looks good, then we can move on from there.
 
Joined
May 16, 2022
Messages
51
Likes
5
  • Did you sand with 120, 220, 320, 400, 600, 800, and 1000 grit sandpaper? Slowly building up in the grits is very important to ensure that none of the board layers are shorting.
  • What are you using to power the Wii?
  • Did you check your trim resistances as per this guide? If that all looks good, then we can move on from there.
I solved it, but thank you for the advice!
 
Top