Question 6 Layer Wii Nand Relocation Vias

[Spartan200]

Ignore the wiring mess. I had this trim working at one point. Does anyone know what the deal is with the two resistors for the nand and how to connect them? Need that explained in Layman's terms. In addition, if anyone has a pinout for the 6 layer board nand vias it would be great.

 

[Spartan200]

*I have reviewed the original post about the resistors for the nand and I'm still not fully understanding how I had it working at one point. Thanks.

 

[Stitches]

I'm surprised that relocation booted once. Those wires need to be shorter. Way way shorter. Also afaik there is no diagram for the 6 layer NAND lines because there are no supported 6 layer trims that are smaller than the OM6. 6 layers are for Wii Micros, Noldendos, and landfill

 

[Mrak408]

I relocated the nand on a 6 layer once, I mostly just used a multimeter to probe continuity with the vias and the nand pads. I never had to relocate any resistor, but there are 2 filtering capacitors that do connect between both sets of 3.3v and gnd pins of the nand.