Recent content by Juninho

  1. RVLoader v2.1

    I understand, my intention is to leave the VGA already enabled, so I reconnect the video cable to finish the installation, I cut the board and I can install the VGA screen which will already have the signal in VGA.
  2. RVLoader v2.1

    Thank you friend
  3. RVLoader v2.1

    I have a question, at the time of installation can I choose VGA mode after Rvloader is already installed? Or is it only at the time of installation?
  4. Worklog Wii U R&D Thread (WURD)

    I'll look into it, thanks
  5. Worklog Wii U R&D Thread (WURD)

    my disk drive is defective, error 160-1400, I bought it like this
  6. Worklog Wii U R&D Thread (WURD)

    incredible project I have a Wii U, I want to use it without the disk drive, from what I understand I should use a picodrive plate, is there any guide to teach the process?
  7. Worklog PS2 90004 New trim

  8. Worklog PS2 90004 New trim

  9. Worklog PS2 90004 New trim

    What did you do here? What did you do here?
  10. Worklog PS2 90004 New trim

    Friend what you did there near the solid capacitors? Turned on trails?
  11. Question please friends help me

    it was a 2.5v regulator, it was closed
  12. Question please friends help me

    updating, I managed to fix it, my board started working again
  13. Question please friends help me

    Today I tried to bring it back to life, without success, but I discovered that I don't have tension in the pwm
  14. Question please friends help me

    I'll explain what happened, I was planning to use the Nintendo Wii adapter, on my 5 inch screen so instead of turning on 5v I turned on 8v, I don't know if that's what killed my motherboard, I didn't test my motherboard, before doing it this hdmi converter installation
  15. Question please friends help me

Top