So frustrating.. unplugged the ribbon and went over again with the magnifying glass. I'm seeing nothing. Would the next step just be purchasing another?
There is nothing grounded to that in the photo. That is a wire I have disconnected in my hunt for the 3.3 short. It must be just hanging out above that. Nothing was touching the IPS driver board when I was testing for continuity between 3.3 and ground.
I did not put put kapton tape on the...
These are two unrelated issues.
Almost done assembling my Ashida and I was getting a short between 3.3 and ground so I started disconnecting my 3.3 connections and I realize its coming through the IPS driver board. On the board itself I am getting a short from 3.3 to ground even when it’s not...
Ha! Your guess is as good as mine, I'm learning as I go. I think I assumed that I could choose between analog and digital. Thanks for catching that! I'll have to rewire tomorrow and update.
Everything is reading correctly except 1.8 is reading at .8 from the PMS. I did leave that hooked up to the audio interface board though, not sure if that would affect anything as it didn't affect 3.3.
I don't know if you can tell from the picture but I do have the composite wired to the front. It's just grounded on the back. I did wire it to the back and moved it wondering if that was the issue.
I did enable VGA, and like I said I got the composite signal when I tested the Wii board by...
I'm into the assembly stage of my Ashida build and I stopped to test it again. I tested after I had finished my Wii trim and got a composite signal but am now getting nothing. The fan turns on so I can tell it is running. Hoping someone can spot something that I'm missing. I tested both...
Another point though, wouldn't you think that if I was making any of these mistakes, that I would end up with different shorts? Why is it always the 3.3 while all others are correct?