i just realized that for testing the board, the power suply i was using wasn't powerfull enought to power my wii, what made my pms turn off. I thought that the problem were the low resistances of the 3.3 v paths, but i was wrong with my diacnostics. I tested the boards with an 18650 cell and it...
Hi, i am new at this so maybe i made a noob mistake. I just trimmed my first wii and sanaded it with sandpaper up to 1500 grit, replaced the u10 and finally i removed the LDO. After finnishing, i cheked the resistances, and all of them were ok except for the 3.3v, that gives me a resistance of...
hi, i am lso doing my first project and i just trimmed my wii today, but i ended up haveing the same problem as you, my wii's 3.3v resistances are at the same range as yours (arround 600 ohms). I have a wii PMS that won't turn on if i weld the 3.3v cables to the board, and i am a little bit...