Question my u10 relocation does not work

[Redduck]

my u10 relocation is not working i used the wire from the dvd power cable from the wii the soldering is not very good i was using the soldering iron at school but when i give it power it gives red light to green to almost instant off and then it does nothing

 

[randomguy]

Hey,first of all try using a single wire,and if you can some finner wire(like 34 awg copper wire ),then you should clean with IPA a little bit around the u10 and globaly around your soldering vias and lastly,check the continuity for the u10,especially around the GND pads(if you can't just make sure to do another the solder,the u10 is a little capricious when it comes to his 3 GND pads ).
Another great thing is using some solderinf flux which can help a lot
In case of,this is the part that I'm talking about and be careful when doing part 4-6

Hope this helps !

 

[Redduck]

Hey,first of all try using a single wire,and if you can some finner wire(like 34 awg copper wire ),then you should clean with IPA a little bit around the u10 and globaly around your soldering vias and lastly,check the continuity for the u10,especially around the GND pads(if you can't just make sure to do another the solder,the u10 is a little capricious when it comes to his 3 GND pads ).
Another great thing is using some solderinf flux which can help a lot
In case of,this is the part that I'm talking about and be careful when doing part 4-6View attachment 45277
Hope this helps !

Thanks i will try it tommorow