Question Ps2 controller relocation

[Syed muhd akram]

Try to relocate ps2 controller port 1
Ack, clk , att ,cmd ,dat
GND and 3v i take from controller port 2
And when turn ps2 on the controller not functioning already check each point and solder was fine but still not working ..

 

[Syed muhd akram]

Chocolate wire is 3v , purple is ground

 

[Syed muhd akram]

 

[cacarot]

after i cut the board I can't use the controller either.

 

[cacarot]

The routing channel has no error but the controller can't be used.

 

[Syed muhd akram]

The routing channel has no error but the controller can't be used.

Did you wire only controller? I have done this before when I only solder joysticks with not memory card the controller is not functioning but when i solder both its ok try solder both controller and memory card

 

[Syed muhd akram]

Did you wire only controller? I have done this before when I only solder joysticks with not memory card the controller is not functioning but when i solder both its ok try solder both controller and memory card

Can i know what lcd will you use on this project cause im still finding one for now my option is 7inch raspberry pi with ps2 to hdmi converter and 480i support the picture is ok better than av and try what this videohttps://youtu.be/YU126mWxNB0

 

[E.Dart]

before when I only solder joysticks with not memory card the controller is not functioning but when i solder both its ok try sol

The routing channel has no error but the controller can't be used.

same issue here do you fixed?