Question Questions about wii ashida

[N3croxs]

Could you use 20awg caliber??

 

[kricket21]

So im buying the remaining parts and I was wondering if this heat sink would work.

Loading…

www.aliexpress.us

 

[DullBoy]

So im buying the remaining parts and I was wondering if this heat sink would work.

Loading…

www.aliexpress.us

This should be fine as its the correct dimensions, it may not come with a pre-applied thermal pad on the back so just be aware of that

 

[kricket21]

so the battery arrived, and the manual thing said to charge it before using it, but they already are charged. do I still need to charge it?

 

[cy]

so the battery arrived, and the manual thing said to charge it before using it, but they already are charged. do I still need to charge it?

I would be more worried about ensuring the voltages between the batteries are virtually identical. The voltages need to be close to in order to avoid any problems with over charging which can lead to fires that are extremely difficult to put out. So if both of your batteries read 3.7V or one reads 3.6 and the other reads 3.7, you should be fine. You just don't want them too far apart in terms of voltage.

To address your original question, if both batteries are already fully charged, then there's no need to charge them. They should right around 4.2V when fully charged, usually slightly under. If the voltage there is a bit lower, it'll be fine to use them in the build for testing so long as you keep the cells balanced (meaning you keep the voltage roughly the same as I stated above). But it probably wouldn't hurt to fully charge the unit after you finish assembly.

 

[kricket21]

when Im wiring up the batteries, can the wires be 30 gauge, or do they have to be thicker

 

[DullBoy]

when Im wiring up the batteries, can the wires be 30 gauge, or do they have to be thicker

No you want 22awg stranded wire for the batteries at least

 

[cy]

No you want 22awg stranded wire for the batteries at least

Yeah, you're gonna want to use 22awg for the batteries as well as for things like the charging wires, and the power wires to the Wii and screen. Anything that draws a good amount of power you'll want 22awg for.

 

[kricket21]

ok thank you

 

[kricket21]

So I put in the screen, but its only receiving ~1 volt. Can I get some help?

 

[JamesPi]

Those wires look way too thin to me.

 

[kricket21]

its weird though because It was working and I was trying to wire a button to the lcd to get composite video, but then all of a sudden it stopped working.