trim

Hi everyone, after I broke my only 4 layer board, I decided to go forward and trim a 6 layer one. After testing that everything was working with the regulators and installing PortablizeMii, I decided to trim it. And to my surprise, it was working. But after working for 2 times, it died. The CPU...

Hi, I hope it's ok if I post this here, but since a few people (like me) don't want/can use Paint.Net, here is the latest version of the Wii-Compendium, converted to .XCF (GiMP Project). It can also be opened with Krita & likely many more! Download (Full / Resized)...

The discord addicted should already have seen a lot of those pics, but i wanted to share them for all ppl on BB :) Also i think it's the best i can do for celebrating my one-hundreds post in this community! Warning: Some of the shown mods are still in a Proof-Of-Concept, so don't try this at...

Hello there. I registered just a moment ago. So, I bought a Wii to try OMGWTF on and will most likely turn it into a portable and some kind of dock with GC ports and stuff. Main goal here is ability to play GC games, but I'm planning to keep BT and wifi. Progress so far consists of a succesful...

Introduction This guide and its graphics were created by me, to the best of my knowledge and certain. But without guarantee of correctness! (Even if everything has been tested by me)! So make sure that you know what you are doing, as I will not be responsible for any damage or harm you might do...

So I was wiring up the 3v lines to the bluetooth module and I accidentally hit the ground pin of my power switch (soldered to the board ground) with the end of one of the wires because I'm dumb and wasn't being careful and paying attention. Saw and heard a spark and now the board wont boot. The...

As the title implies, I've got no rumble in my cube controller after a trim on a 4 layer board. The rumble worked before the trim and the controller is getting 5 volts so I'm not really sure what's going on here. The trim works fine as well (obviously). I have a wasp fusion installed on a cube...

Well, just like the title says my trim isn't booting. The cpu and gpu both heat up slowly. The board worked just fine before the trim, and I have checked all of the regs multiple times. U10 is wired up with the trace cut and is receiving power. Nothing happens for a bit when I turn the power on...

I trimmed my wii(6layer) but now it won't power on plz help.could this likely be caused by not sanding with the right grit? Or did I just cut something important? Unless I have to if rather not do the omgwtf trim. This trim will fit fine in my case.