Search results

No I didn't trim the wii I bought it on Aliexpress with YPBPR as my video option.

Once you trim the wii you can't change the video because i bought composite as video not VGA.

But thats more expensive then what am I going to do with the composite one?

Great looks like I am going to have buy a new board because the one I got was impossible to remove the ports without melting all of them off I don't want to get the blue board because its going to get damaged again I need a green one and I don't have like any money so I hope there is some way to...

How will I use it if both av 1 and av 2 is ripped? And it looks like quanity one by the looks of it pad of 2 or 3 or 4 K seems to be the only one not ripped because I can't tell if thats going to work because wouldn't I need a new one?

But im talking about the driver board for the screen not the TV because I don't know which pad because I really need help because I have seen that video already. Because how will that work on my screen because thats meant for the tv. How will I find forums if most people are not doing composite?

I have to do composite because the board is already trimmed so I need to know what wire for the composite on the driver board like use an actual composite wire like yellow or just a regular wire and on which pad for ground and the one for the other because I can't move on until I know the...

By silkscreen do you mean by the lettering on the back of the driver board because I don't know where to connect the wire on the driver by even looking at it. Since I don't really know this plus there is multiple grounds and it I still don't know where to put it even if it says "VGA -YPBPR IN"...

I didn't know how vga would have worked because I have never heard of it. So I ordered a YPBR wii motherboard off of Aliexpress since I messed up my wii motherboard.

Here are pictures of what I am talking about.

I have looked everywhere for this part even the tools needed thread and there is no post saying anything about for the wiring the legs of the speakers with connecting them to the pads since the legs can't make good contact with the pads. I don't want to do the wrong one so I need help knowing...

Great I have to spend another $90.

I accidentally touched a different area with the black probe it was outputting 1.8v but then now it won't output anything so I think I just completely made it dead.?

Here forgot to reply to you instead.

Yes! Here it is!

The 1.8v for the pms 2 is showing 0.11 but the others are correct so does this mean i need to order a new one?

So I tested the 1v, 1.15v, and 1.8v. But only the 1.8v was giving a reading no other one and I was doing 20k v setting so does this mean my pms 2 short circuited and that means I need to order a new one?

What do I touch with the red probe when testing the voltage on the pms 2 to check if its outfitting voltage right?

For the U10 do you mean the regulator area or putting in the wire in the dot with the solder on it? Also by the wires exposed do you mean by the wires are too long with the plastic covering off or they are not twisted and tinned enough? Yeah i haven't put flux on them and i do have some in a...

But the av port is on the board so I should be getting a signal because they only do this if the av port is removed because how would I do it if the port isn't removed? Dubinsenhower uses a loose composite cable to attach at the bottom of the port but I can't since the pins are in the board.