Search results

Sorry I should of responded. I got it figured out. It seemed soldered good enough but it wasn't. I realized I have the wrong size wire. I have 28awg. So I ordered 34awg like the guide says. It will be here Wednesday. After it was posted in another thread to push the wire into the via and...

When soldering to the vias, does it matter which i use? I know it shows both in the guide. Just wondering because I get the error you receive after installing bbloader, and you boot with SD card in, instead of USB.

I just went through this. I found my issue. I was burning the enamel of the wire instead of using solder. So the solder would never really stick until I used solder to burn it like it says in the guide. Also I had to change my solder tip from a skinny point to a slightly more blunt. I also had...

Thanks. You got me in the right spot. I cleaned that whole area, and seen i also unsoldered a component next to that. Reattached it, and resoldered the wire back, and it fixed it. Now just need to check my usb data wires. The usb doesn't show up, so it gives a boot error. At least I know the...

The line in the screen is scrolling. Just like a old crt, which i know I'm using av, so maybe the output from wii board isn't right? Screen is fine, because menu pulls up like normal for screen.

Can someone look at this and see where I might off went wrong?

Used desoldering wick, cleaned it up, soldered all the pads, reattached everything and all is fine.

Yeah I'm going to pull it out. Probably should of when I got it.

Haha, it's really 28awg. It's silicone coated, so it looks thicker.

Not that great of a picture. Don't know what other picture I should post.

Ok. Give me a minute

Bought a partially built gboy kit. The RVL pms 3v3 is not working. What should I check on the board? It was working then stopped. Nothing smoked or anything. Just stopped putting 3v3 out.

Yeah I have the magnet wire now. When I first started that trim, it had not delivered yet, but wanted to verify before the trim. I will replace soon.

This is the start of my Largeii Wii build. Figured i would post a worklog thread of the build progress. Beginning of the design (WIP) My work area and motherboard trim. The build will use a large 7inch IPS screen, wii motherboard, switch joysticks, fullsize buttons and dpad.

He responded to me. I purchased it. @BocuD

I +1 all that. I need a exit key bad. I hate holding power to exit, then restart.

Pretty sure bbloader needed installed and verified working, before the trim. Once trimmed is to late.

Nice project. When you're ready, I'm interested in the fusion files. I was doing the louii, but seeing yours, made me decide on a 7in screen.

Did you ever sell this, or is it still up for grabs?

Hello everyone. Just saying hi!!. Ready to build one. Already have built 2 portables before here.