Recent content by YT N9-Volt

And I don't know what wire for L and R running the contacts for the controller board in the bracket thing?

ive looked everywhere even the tools needed and there no post saying ashida speakers when wiring them and I don't want to do the wrong one? This is for the controller board since the speakers don't make good contacts.

Great I have to spend another $90.

I accidentally touched a different area with the black probe it was outputting 1.8v but then now it won't output anything so I think I just completely made it dead.?

Here forgot to reply to you instead.

Yes! Here it is!

The 1.8v for the pms 2 is showing 0.11 but the others are correct so does this mean i need to order a new one?

So I tested the 1v, 1.15v, and 1.8v. But only the 1.8v was giving a reading no other one and I was doing 20k v setting so does this mean my pms 2 short circuited and that means I need to order a new one?

What do I touch with the red probe when testing the voltage on the pms 2 to check if its outfitting voltage right?

For the U10 do you mean the regulator area or putting in the wire in the dot with the solder on it? Also by the wires exposed do you mean by the wires are too long with the plastic covering off or they are not twisted and tinned enough? Yeah i haven't put flux on them and i do have some in a...

But the av port is on the board so I should be getting a signal because they only do this if the av port is removed because how would I do it if the port isn't removed? Dubinsenhower uses a loose composite cable to attach at the bottom of the port but I can't since the pins are in the board.

Also both silver squares are heating up and the pms is hot as well so idk what's the issue.

I also did some resistance checking but the next one for the ground 1.8 volt was some reason like 0.02 which i don't know why but I tried using either 20k V or 200 V for my red Gardner manual multimeter from Menards. But I never used a multimeter before.

I cleaned it up and I did i found out that i did forget to wire the 1 volt and I already did sand it before I posted on here from 80 grit to 800 grit I just didn't sand the outer motherboard part where I didn't trim since that should be fine. But I did the relocation I removed the regulator and...

Im having trouble getting this to boot idk what I did wrong. I follow the YouTuber Dubensinhower the one who did a tutorial and I hooked up everything he did except I kept my av cable port on my motherboard to test to make it easier and then if it worked I would trim the rest off. But I can't...