Recent content by loopj

  1. loopj

    Ghosts GC+ 2.4 firmware compatible with GCVideo 3.1 - Fujiflex

    I looked into this further - it definitely is a turnaround time issue. Essentially this is a problem with GC+ sometimes replying "too slowly" (for GCVideo) to joybus commands. GCVIdeo snoops on complete command/response transactions, and "closes" a transaction after 38us of silence, so a...
  2. loopj

    Ghosts GC+ 2.4 firmware compatible with GCVideo 3.1 - Fujiflex

    Cool stuff! I always assumed this was either a turnaround time or jitter issue. I'm confused at why adjusting the pulse period was part of the fix though? I'm curious if this was an LLM assisted fix, or just the writeup was?
  3. loopj

    The Sega Mega Gear - Giant grown up Game Gear

    Holy smokes this looks great!
  4. loopj

    Model Aftermarket GameCube and N64 Female Connectors

    Hey folks, I modeled the common AliExpress aftermarket N64 and GameCube female connectors, and created a KiCad footprints for both. You can find them here: https://github.com/loopj/n64-controller-port https://github.com/loopj/gcn-controller-port Hope this is helpful!
  5. loopj

    Worklog Project Short Stack

    At the time it was much easier and cheaper to source GL835s and they have the advantage of not needing 5v as legend says as well as being much smaller. Unless hand soldering is a top priority I would always use a GL835 these days.
  6. loopj

    Loopj's Kawaii

    Finally finished up my Kawaii build! I decided to hand assemble the boards without a stencil, I regret doing this and would highly recommend getting a stencil as recommended. However, it is possible if you are insane (cc @Lazr). Here are some noodz: This design is so clean and...
  7. loopj

    Flashfi.re – Yveltal's Web Store

  8. loopj

    Question RVL DD vs. standard driver board

    Video quality is similar to VGA, but the RVL-DD is smaller, has fewer wires and a tighter integration with RVLoader (brightness control, etc).
  9. loopj

    Worklog My journey to omega

    It is probably not dead, the trim still looks fine. When you sand or trim further, any cold joints are likely to pop off. The power and grounds on your AVEflex look suspect I would reflow those. Also check closely around the edge for areas you need to resend. Also check if all the vias on your...
  10. loopj

    Worklog "Spring"

    Looking great!! Nice work
  11. loopj

    Worklog "Spring"

    wtf this is insane!! nice work @Sdouyoulink
  12. loopj

    [2025 Contest Entry] Classroom64

    HOW IS THIS SO CLEAN!!! Great work dude. The fact that it hinges open is so slick too.
  13. loopj

    Worklog [2025 Summer Contest] Windows 98 Handheld v2

    This turned out so nice!! Great work
  14. loopj

    [2025 Contest Entry] Classroom64

    Turned out great!! Can’t wait for the full write up
Back
Top